Want to watch this video? Sign up for the course here. Or enter your email below to watch one free video.

Unlock This Video Now for FREE

This video is normally available to paying customers.
You may unlock this video for FREE. Enter your email address for instant access AND to receive ongoing updates and special discounts related to this topic.

What we are going to do now is take a look at how to install an AED cabinet. To begin the installation, measure from the floor up and choose your desired height, which should between 1 and 1.35 metres from the bottom of the cabinet. Drill your first hole and insert the wall plug and temporarily insert a bolt into the top right-hand hole. Tighten slightly to help support the weight of the cabinet while you then mark out the other holes. Place your Spirit level on the top of the cabinet and move it until it is perfectly level, and then mark the other three drilling positions through the holes in the back of the cabinet. Remove the first bolt from the cabinet, and take the cabinet down, carefully placing it on the floor.

The next step is to drill the remaining three holes. These need to go into a depth long enough to take the entire bolt included in the fixing pack. For the next part, you will need somebody to help you. After you have drilled and cleaned all of the four holes, insert the wall plugs tapping them in gently with a hammer until they are flush with the wall. You will then need an assistant to hold the cabinet and offer it up to the holes that you have drilled. Take your bolts and insert them first through the steel washer, and then through the small nylon washer, and put them through the holes in the back of the cabinet and then into the wall plugs that are in place where you have previously drilled your holes. We recommend the use of large spaces if you are mounting your cabinet on an uneven surface.

Once all four bolts are in place you can begin to tighten them. Do not tighten any bolt all the way, rather go around in a clockwise motion doing four or five turns in each bolt until the cabinet is securely fastened to the wall. Do not over tighten these bolts as this can bend the cabinet out of shape and cause problems when closing the door. After you have drilled and plugged the four holes, you will need to decide where your electrical supply is going to enter the cabinet. Although the unit comes fitted with the plug, we do recommend it is hardwired. The entry point for the electrical supply is guided through the gland at the bottom of the cabinet. On no account are you to drill further holes in the cabinet in an attempt to allow easier access for your electricity, as this will void the warranty and also lead to water ingress.

Once the cabinet has been connected to the electrical supply, tighten the gland at the bottom to produce a watertight seal around the cable. When the power supply is connected, the heater will not automatically turn on unless the temperature drops below eight degrees, something which has been tested in the factory before dispatch. If your cabinet comes with a magnetic light, insert the batteries and then connect the magnetic light to the inner front of the cabinet. This light is motion-sensored and it will turn on when the door is opened. Once the cabinet is operational, for the first four weeks, the door will often be stiff to open and close. This is due to the silicone gasket on the inside of the door which requires a bedding in period. During this period, you may have to push quite firmly on the door to get it locked but don't slam the door.